| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
| Home | Register | FAQ | Donate | Members List | Calendar | vBGarage | Gallery | Search | Today's Posts | Mark Forums Read |
|
||||||
 |
|
|
Thread Tools | Search this Thread |
Rating: 
|
Display Modes |
|
#1
07-30-2012, 09:07 PM
|
|||
|
|||
|
need help on 2006 outlander 800 right rear axle
blew the cv on my right rear axle (rim side of axle) and cant figure out how to take my axle out. The axle itself still looks perfectly fine I think I will just need a cv and a bearing. If anyone has instructions on how to remove axle and replace the cv and bearing , also how to clamp rubber boot back on that would help alot !! thanks
__________________
__________________________________________________ ___________________ 2006 OUTLANDER 800R XT 29.5" outlaw 2's on msa nukes Dalton clutch kit Custom snorkles highlifter springs supertrapp mudslinger pipe Rad Relocate TEAM BUSHWACKERS IF YOU AINT BURNIN GAS , YOU AINT HAULIN ASS
|
|
#2
07-31-2012, 12:04 AM
|
||||
|
||||
|
Pull your wheel and hub off, unbolt bottom bolt on both shocks, drop swing arms so you can pull axle out of swing arm, then you can either grab the axle push in and give a solid pull out if that doesn't work wrap a 1 inch strap around the axle hub at diff then tie it to a sledge hammer and give it a few good pulls and it should come out....
Message off road traction and buy a after market Rhino Axle cheaper than stock and seem pretty decent.... Good Luck!!!!! Shane
__________________
09 Can Am 800r XT 98 mxz 500 with 92 mach 617 05 F7 mbrp can 1 3/8" track 10 Crossfire 8SP 00 Big Bear 350 07 F-150 crew Lariat 00 dodge dakota 4X4 (POS)   "IF IT FLIES IT DIES"
|
| The Following User Says Thank You to waterhen19 For This Useful Post: | ||
bbertram (07-31-2012) | ||
|
#3
07-31-2012, 12:16 AM
|
||||
|
||||
|
If you need a new axle let me know.
__________________
----------------------------------------------------------------------------------
Brent Bertram -- sales@offroadtraction.com OFFRoad Traction! OFFRoad Toy Accessories -- ATV, Truck, Car tires & wheels ---------------------------------------------------------------------------------- Like us Facebook!
|
|
#4
07-31-2012, 12:20 AM
|
|||
|
|||
|
Thankyou , I don't think I will ned a new axle because I only shattered by cv and bearing , but I will let you know once I get it out , still won't be back to it till middle of august so ill keep you guys posted on how it goes , thanks for the help waterhen !
__________________
__________________________________________________ ___________________ 2006 OUTLANDER 800R XT 29.5" outlaw 2's on msa nukes Dalton clutch kit Custom snorkles highlifter springs supertrapp mudslinger pipe Rad Relocate TEAM BUSHWACKERS IF YOU AINT BURNIN GAS , YOU AINT HAULIN ASS
|
|
#5
07-31-2012, 08:03 AM
|
||||
|
||||
|
The outside cv can not be taken off like the inner cv, you need to buy the whole shaft assembly so a rhino might be cheaper and way easier to do and has a factory seal
__________________
2012 Outlander XMR, Dual LTE's, Custom 2" snorkel, Increased Rad angle, PC5 w/custom tune, 2.5" Rox handlebar riser, CVtech Primary w/650 helix, 1.5" Rubberdown SpringSpacers 2008 Grizzly 700, Two Brothers Slip on, Custom 2" Snorkel, 5" Rox riser, Pro Taper bars, Ricochet Skids, EPI clutch spring, and some L.E. engine parts
|
|
#6
07-31-2012, 09:42 AM
|
||||
|
||||
|
its cheaper to buy the complete rhino axle than the BRP cv joint...
to do the clamp its easiest to have the pliers from BRP, but in a pinch adjustable pliers can work but its a *****...
__________________
 2011 CoMmAnDeR 4 sEaTeR in RED, 30'' Silverbacks on M12 Diesel rims, spring spacers & 1'' wheel spacers, 2'' snorkels, front bumper, HMF Swamp Series XL, running 030 belt, 40'' Rigid LED, SSV WP-0U4 stereo, Ricochet full skid plates, BRP RACE BOX & Frame MODDOO 1200 freeride with some tweakin' & stretchin', VE 146 tunnel, TOMS EA skid, XP plastics, FOX evols alround, and more good stuff from rapid bike and MBRP
|
|
#7
08-02-2012, 05:21 PM
|
|||
|
|||
|
Oh ok sounds good , who can I get one from ?
__________________
__________________________________________________ ___________________ 2006 OUTLANDER 800R XT 29.5" outlaw 2's on msa nukes Dalton clutch kit Custom snorkles highlifter springs supertrapp mudslinger pipe Rad Relocate TEAM BUSHWACKERS IF YOU AINT BURNIN GAS , YOU AINT HAULIN ASS
|
|
#8
08-02-2012, 05:45 PM
|
||||
|
||||
|
Quote:
__________________
----------------------------------------------------------------------------------
Brent Bertram -- sales@offroadtraction.com OFFRoad Traction! OFFRoad Toy Accessories -- ATV, Truck, Car tires & wheels ---------------------------------------------------------------------------------- Like us Facebook!
|
|
#9
08-02-2012, 05:45 PM
|
||||
|
||||
|
Maybe.....
Quote:
__________________
 ~BRENDIN~ 07 800 can am outlander 27" mudzillas snorkels :) hmf pipe and optimizer 3000 lb Smittybilt winch Front A arm skid plates The deeper you're, the more fun you're having
|
|
| Tags |
| outlander |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2006 Can-am Outlander 800 Max XT | Powerstroke16 | Classifieds | 6 | 09-28-2011 03:53 PM |
| FS - 2006 Bombardier Outlander 800 Damaged | OFFROADLIFE | Classifieds | 24 | 09-02-2011 04:54 PM |
| 800 Outlander Real Axle Seal | JoeCool | Can-Am ATV | 13 | 08-30-2010 09:03 AM |
| rear axle | stealth800 | Polaris ATV | 5 | 07-16-2010 10:30 AM |
| bomb 800 h.o. efi outlander xt 2006 | honda250rx2 | Can-Am ATV | 22 | 10-07-2006 09:13 PM |
Linear Mode
